In-vitro mapping of E fields induced near pacemaker leads by simulated MR gradient fields

Magnetic resonance imaging (MRI) of patients with implanted cardiac pacemakers is contraindicated but some clinicians condone scanning certain patients. We assessed the risk of inducing unintended cardiac stimulation by measuring electric fields (E) induced near lead tips by a simulated MRI gradient system.

The objectives of this study are to map magnetically induced E near distal tips of leads in a saline tank to determine the spatial distribution and magnitude of E and compare them with E induced by a pacemaker pulse generator (PG).

Methods: We mapped magnetically induced E with 0.1 mm resolution as close as 1 mm from lead tips. We used probes with two straight electrodes (e.g.

wire diameter of 0.2 mm separated by 0.9 mm). We generated magnetic flux density (B) with a Helmholtz coil throughout 0.6 % saline in a 24 cm diameter tank with (dB/dt) of 1 T/sec (1 kHz sinusoidal waveform).

Separately, we measured E near the tip when connected to a PG. Measurements were non-invasive (not altering the leads or PG under study).

Results: When scaled to 30 T/s, magnetically-induced E exceeded the E produced by a PG.

The magnetically-induced E only occurred when B was coincident with or within 15 msec of implantable pacemaker's pulse.

Conclusions: Potentially hazardous situations are possible during an MR scan due to gradient fields. Unintended stimulation can be induced via abandoned leads and leads connected to a pulse generator with loss of hermetic seal at the connector.

Pacemaker-dependent patients can receive drastically altered pacing pulses.

Author: Howard BassenGonzalo Mendoza
Credits/Source: BioMedical Engineering OnLine 2009, 8:37

Published on: 2009-11-25

Copyright by the authors listed above - made available via BioMedCentral (Open Access). Please make sure to read our disclaimer prior to contacting 7thSpace Interactive. To contact our editors, visit our online helpdesk. If you wish submit your own press release, click here.

Comments Page 0 of 0

There are currently 0 comments to display.

+ Add New Comment

Custom Search